By submitting this form you agree that the information provided are exploited by EVE Audio to process your request.
Information about your personal data:
The only collected personal data is the data provided in this formular.
Your data will be directly treated by EVE Audio.
Your data will only be used to process your request.
Your data will be only accessible to the concerned EVE Audio staff members.
Your data will never be shared with any third party.
Your data will be kept during one year after your request has been processed.
In accordance with the European GDPR regulation you may exercice your right to access your personal data by requesting them . In your message you may also ask us to amend or delete your personal data.
The SC208 is the last in our two-way system series featuring the ease of use and detailed timbre reproduction.
With a larger woofer and more powerful amplifiers, the SC208 is used as a main speaker in a lot of professional and home-studios. If you're looking for a capable and detailed set of above-average size monitors try the SC208.
SC208 – MCK Bydgoszcz
With the SC208, you will be able to extend your bass frequency response down to 36 Hz. Our custom-made 8" SilverCone woofer driven by a sophisticated low distortion copper cap magnet system with our 1.5" voice coil will guarantee that you will not run out of bass response when it comes to the critical listening and comparison of your mixes. The result is a very tight and dynamic bass, along with the usual greater linear excursion provided in every other EVE Audio model.
Our PWM amplifier, with protection-limiting, is able to deliver a short-term output power of 150W for a maximum output level of 112 dB (SPL @ 1m). So you can be sure that there will be plenty of power to make critical and precise judgements over your mixes.
The SC208 also uses our proprietary AMT (Air Motion Transformer) RS2. The RS2 stands for Ribbon System 2, meaning it has a bigger front plate and a larger magnet driving the motion with the utmost efficiency.
As with every other EVE Audio speaker, you get both balanced XLR inputs and unbalanced RCA inputs for greater convenience.
With every EVE Audio speaker, you also get high resolution DSP electronics. One push knob operation and you will have access to accurate volume control and several different filter settings that will help you tailor your monitors to the way you work.
If you always avoid digital processing, we've got you covered. The DSP engine is supported with a high quality A/D converter (24bit/192kHz) from Burr-Brown, which delivers a pristine signal to the DSP section. And since the PWM amplifiers are directly connected to the DSP, no additional conversion is necessary. Please visit our Technology page to learn more about our DSP philosophy.
It's all in the geometry. One of the downside effects of port compression is bass distortion. As you turn up the volume, the efficiency of the port reduces and distortion will increase.
We opted for a large rear rectangular port with no hard edges for our bass port designs. That's one of the reasons EVE monitors have a high efficiency on the lower frequencies.
The results? High sound pressures with tight and punchy bass frequencies that don't cause port distortion. Crank up the volume, and EVE will deliver a round bass. And with no holes to look at every time you glance at your speakers.
Free-field frequency response (1/6 oct.) Red = 0° / Green = 30° horizontal off-axis
Distortion Orange = 2nd / Green = 3rd vs frequency response (red)
Polar pattern (1m) Red = 200Hz / Green = 1kHz / Blue = 5kHz
|Dimensions (WxHxD) [mm]||255 x 390 x 330|
|Dimensions (WxHxD) ["]||10.04 x 15.35 x 12.99|
|Free-field frequency range (-3dB)||36Hz - 21kHz|
|Maximum SPL @ 1m||112dB|
|Number of amplifiers||2|
|Output power (woofer)||150W|
|Output power (mid-driver)|
|Output power (tweeter)||50W|
|Volume||-inf. - +6dB|
|System volume (Satellite & Sub)|
|High-shelf filter (-5dB - +3dB)||> 3kHz|
|Mid EQ (-3dB - +3dB)|
|Desk filter boost (0dB - +3dB)||80Hz|
|Desk filter cut (-5dB - 0dB)||160Hz|
|Low-shelf filter (-5dB - +3dB)||< 300Hz|
|LED brightness setting|
|Level-lock dip switch|
|Filter-lock dip switch|
|Woofer-change dip switch (L/R)|
|Input level dip switch|
|Standby dip switch|
|Satellite filter dip switch|
|Switchable Satellite filter|
|Variable Subwoofer filter|
|XLR in (impedance)||(10k)|
|RCA in (impedance)||(10k)|
|Digital optical in|
|RCA subwoofer out|
|XLR in left (impedance)|
|XLR in right (impedance)|
|XLR in LFE (impedance)|
|XLR out satellite left (impedance)|
|XLR out satellite right (impedance)|
|XLR out LFE (impedance)|
|Backmounting thread inserts|
|Mic stand thread inserts|
|Weight [kg/lb.]||10.9 / 24|